1 / 2
Filament shelf bracket for Multiboard
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bracket for a 20 mm plastic tubing filament spool shelf for Multiboard
- Rating
- 5 / 5
- Likes
- 113
- Downloads
- 538
- Makes
- 5
- Views
- 2,738
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
A sleek bracket for building a filament shelf out of 20 mm plastic tubes and mounted on a multiboard. Will accomodate both regular and small spools.
You will need:
- Two plastic tubes (electrical tube or any tube or shaft/dowel) with 20 mm outer diameter (about ¾ inch).
- As many bracket as you deem necessary for the weight of your filament spools. A spacing of 50 cm should be sufficient.
- UPDATE: One 13 mm and one 20 mm small thread multiboard T-bolts per bracket. Plain head or flat head is your choice, but plain head on 20 mm bolt is recommended.
I updated the recommendation to T-bolts because I had two bolt sheer off leaving the shelf hanging precariously. The regular bolts can't take the weight. So if you don't want your shelf come crashing down, switch to T-bolts and do not overtighten them!
Print flat on it's side, no supports needed.
Print with the plastic of your choice, recommended is PETG with 5 walls and 20% infill.
UPDATE:
A variant for 24 mm shaft/dowel has been added.
Variants for mounting directly to wall with 5 mm screws has been added.
Changed from STL to STEP files and changed default orientation.