1 / 2
Filament shelf bracket for Multiboard
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket for a 20 mm plastic tubing filament spool shelf for Multiboard
- Ocena
- 5 / 5
- Polubienia
- 113
- Pobrania
- 538
- Wydruki
- 5
- Wyświetlenia
- 2738
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 5) (Komentarze: 9)Remiksy (1)Kolekcje (284)Powiązane
A sleek bracket for building a filament shelf out of 20 mm plastic tubes and mounted on a multiboard. Will accomodate both regular and small spools.
You will need:
- Two plastic tubes (electrical tube or any tube or shaft/dowel) with 20 mm outer diameter (about ¾ inch).
- As many bracket as you deem necessary for the weight of your filament spools. A spacing of 50 cm should be sufficient.
- UPDATE: One 13 mm and one 20 mm small thread multiboard T-bolts per bracket. Plain head or flat head is your choice, but plain head on 20 mm bolt is recommended.
I updated the recommendation to T-bolts because I had two bolt sheer off leaving the shelf hanging precariously. The regular bolts can't take the weight. So if you don't want your shelf come crashing down, switch to T-bolts and do not overtighten them!
Print flat on it's side, no supports needed.
Print with the plastic of your choice, recommended is PETG with 5 walls and 20% infill.
UPDATE:
A variant for 24 mm shaft/dowel has been added.
Variants for mounting directly to wall with 5 mm screws has been added.
Changed from STL to STEP files and changed default orientation.