Yet another Cartographer 3D / Beacon 3D Coil Mount Anycubic Kobra Neo

yet another cartographer 3D/Beacon probe mount for the anycubic kobra neo. 

this is my version of a mount for the coil part of cartographer 3D or beacon 3D probe, i designed it back days as a klicky probe mount, but then switched to cartographer :)

This is V1 - and still work in progress, i will update model if there are changes, but for now it works and fits like a charm,

Instructions:

which set should u order:
i recommend the flat pack set ! more flexibility, but u have to solder it completely by yourself. You should have the equipment and some solder skills :) …

what did u need ?
With this mount you need two longer M3 Screws, to replace the lower stock ones on the printhead. I guess 15 - 20mm screws are fine. 
 

mounting the coil part:
Mount the cartographer, you can use the two M3 Screws which are delivered in the set. I recommend two M3 heat-inserts, to give it more strength, but should work without them too.

Remove the lower two screws at the back of the printhead, place the mount with the cartographer and screw-in the longer M3 screws, u can use M3 heat-insert too, but it works fine without.

mounting the PCB part:
to mount the pcb part, i would recommend to use my pcb mount, which u can download here:

Download:
https://www.printables.com/model/842823-anycubic-kobra-neo-cartographer-3d-pcb-mount-holde

Design Goals:
- optimal distance to bed (2-3mm)
- as near to the nozzel as possible
- tight, sturdy & firm so no wobble at the mount part which is essential for a good mesh
- easy & quick to mount

probe offset:
you should use this offset in your cartographer config section as probe offsets

X: 0
Y: 28

print:
PLA is fine, 0,2 Layer & 15 % Infill should work - i recommend some tree supports

History:
05/01/2024 - offset updated