Filament holder for CR-10v3 with guide
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€6.23 – €7.61 net (excluding VAT)
For file: filament-stander beta V2_PLA_Creality CR-10 V3.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €6.92 excluding VAT (range midpoint).
- Weight reported by the author
- 70 g
- Print time reported by the author
- 7.72 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Added guides so the filament comes straight down after the filament sensor regardless of the position of the extruder.…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 19
- Makes
- 0
- Views
- 375
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Added guides so the filament comes straight down after the filament sensor regardless of the position of the extruder.
filament-holder.stl:
Is not changed.
filament-stander V2.stl:
Tested and working.
My CR10V3 came with guide rollers underneath the filament sensor.
i edited the design so the roles can be placed underneath the filament sensor again.
also created 2 slots so the filament holder slides all the way down over the original guide roller mounts.
filament-stander beta V2 non roller.stl:
Version with solid guide for printers that came without rollers.
Not tested, doesn't fit my printer.
Let me know if there are any problems.
I would suggest putting something in place to prevent the filament getting stuck under the spool.
This can be achieved by putting a short length of filament through the
hole's in the side of the spool (white length in the picture)
This will vary depending what spool is used.
Print Settings:
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10%
Filament:
PLA