1 / 12
KAD Air Slinger - Ender 3 fan duct (a better version of the Vortex) — image 1
1 / 12

KAD Air Slinger - Ender 3 fan duct (a better version of the Vortex)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Based off of Vortex - Just better in every other way

Rating
0 / 5
Likes
22
Downloads
169
Makes
1
Views
1,119
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

If you would like a kit made that you could buy with all the parts preassembled with instructions comment on this model or use the messaging service in Printables

 

Note: Still work in progress as of this date. If you want different magnet sizes please request. I only use 5mm Magnets for most of my projects, but I am happy to add other sizes if you'd like. 

 

Progress:

  • 5/23/24: Print original fan cover realize how turbulent the air is and the work began
  • 5/25/24: V1 - V5.2 were created. Air flow is much better (refer to pictures)
  • More magnet sizes and ABL adjustments to come! Please comment on what magnet sizes you'd like to see and what probe mounts you'd like.
  • 5/26/23: Added different magnet options all still 5mm wide.

 

Differences from original model (what this was remixed from)

  • No sharp corners where the air flows (air doesn't like hard turns)
  • Air actually creates a pressure directly under the nozzle not 2mm below it.
  • Has a separate mounting plate if you are using a CR touch all you need instead is a shorter magnet.
  •  Has different magnet sizes 
  • Doesn't have different fan sizes (I've never even seen a 2510 Axial fan in my life)
  • STEP file is truly complete
  • Radial fans are special and don't have a constant pressure output across the entire outlet so I've optimized where that should be so that both outlets have the same pressure.

Printing requirements

  • Requires some support, Less than original model.
  • ASA or ABS or any other high temp material. Maybe PETG, definitely not PLA
  • Finer layer heights are preferred for less turbulent air-flow

Parts Needed

  • 5015 radial fan
  • 3010 axial fan
  • Magnets (Depends on what style you choose)
  • 2 M3 x 20 screws to mount 5015 fan
  • 4 M3 x 12 screws to mount 3010 fan

Installation 

  • insert the 8 magnets, should be a slight press fit
  • be sure magnets are on the correct way so they attract (ie. cover has N and mounting bracket has S)
  • Remove cover to access hot end assembly
  • remove the two screws holding the hot end assembly
  • slide mounting plate onto where the hot end assembly sits. it should slide over the two standoffs
  • reinstall hot end assembly 
  • wire the two new fans
  • install fans into cover
  • slide over on
  • make sure cover is slightly above the base of the nozzle
  • if cover is below nozzle a new mounting bracket will need to be made to lower it.

Tags