WeatherFlow Meter Weather Vane
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a weather vane for a WeatherFlow Meter.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 136
- Makes
- 0
- Views
- 1,002
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a weather vane for a WeatherFlow Precision Shooting Weathermeter. This mounts to a ¼-20 tripod mount.
I also included a pdf file for the spindle if you wish to make from AL or other material.
Note: I did not model the ¼-20 threads for Hub Cover and Jam Nut. You can let the bolt cut the thread or tap the two part. I did model the threads in the spindle.
BOM:
(1) ¼-20 bolt .75 inches
(1) 4-40 countersunk screw .25 inches
(2) 8 x 16 x 5mm sealed ball bearing
(6) 1/4oz lead weights
(1) Center Hub
(1) Spindle ( I made this from AL, but it can also be printed)
(1) Hub Cover
(1) Meter Jam Nut
(1) Wind Vane
Assembly Instructions.
- Insert bolt in hub and install hub cover.
- Insert upper bearing to upper end of hub.
- Insert lower bearing to be flush with lower surface of hub.
- Insert wind vane into hub and install screw.
- Insert weights in lower side of hub pointer.
- Screw meter jam nut on bolt.
- Screw meter onto bolt until it bottoms out then back it off until positioned correctly.
- Tighten jam nut to meter.