Space Cop badge from Red Letter Media's movie
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Space Cop's badge, which was used as a prop in the movie
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 18
- Makes
- 0
- Views
- 178
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Share Alike
I took the logo for Red Letter Media's upcoming movie Space Cop and made a 3d badge out of it. I cooked up a batch of these and mailed them off to RLM to use for whatever purposes they deemed necessary. As is turns out, they used the badge in a few places, including Patton Oswalt's costume.
Instructions
I printed these badges at .2 layer height in blue PLA.
I printed at 100% infill to keep the infill from showing on the sides. Once printed, I masked the edges of the planet rings with masking tape and painted them with a gold-colored oil-based Sharpie. I then went over the tops of the letters S and C with the same paint.
http://www.amazon.com/Sharpie-Oil-Based-Markers-Colored-1770458/dp/B003YDYO1Q/ref=pd_sim_op_2
I've found that the silver and gold paints from that set can look really amazing on 3d prints. The only catch is that the tip of the sharpie is a bit wide, so that limits the fine detail work you can do with it.
Category: Coins & Badges