Space Cop badge from Red Letter Media's movie
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Space Cop's badge, which was used as a prop in the movie
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 178
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Share Alike
I took the logo for Red Letter Media's upcoming movie Space Cop and made a 3d badge out of it. I cooked up a batch of these and mailed them off to RLM to use for whatever purposes they deemed necessary. As is turns out, they used the badge in a few places, including Patton Oswalt's costume.
Instructions
I printed these badges at .2 layer height in blue PLA.
I printed at 100% infill to keep the infill from showing on the sides. Once printed, I masked the edges of the planet rings with masking tape and painted them with a gold-colored oil-based Sharpie. I then went over the tops of the letters S and C with the same paint.
http://www.amazon.com/Sharpie-Oil-Based-Markers-Colored-1770458/dp/B003YDYO1Q/ref=pd_sim_op_2
I've found that the silver and gold paints from that set can look really amazing on 3d prints. The only catch is that the tip of the sharpie is a bit wide, so that limits the fine detail work you can do with it.
Category: Coins & Badges