Zero Waste Water Distributor Lid Maximize Growth for Hydroponic Tower

This Hydroponic Tower Water Dispenser Lid is made for the common 3d hydroponic tower systems found online. It uses a 1/4th irrigation tube for the water line.

This will save you an extra module to print (top res or distributor), space, save you water, electricity and increases efficiency of your system for explosive growth!

It integrates a low profile Lid (remixed) with a water dispenser ring (customized) into a single system that will flow water down all pots.

You can get rid of your top reservoir and use that space to include another grow module if you want.

V1 Full Width Waterfall:

This V1 Lid will distribute water evenly to the sides of your hydroponic tower system instead of wasting it with a ‘cool’ rain effect that usually gets wasted right down the middle of your tower offering you absolutely no benefits. This brings the water down in a water fall/water sheeting effecting down the sides of the tower.

V2 Raindrops:

V2 Lid brings the water down in a hybrid rain drop and waterfall effect. The waterfall will follow the sides of your tower and the raindrops will spread out a little more covering some areas in towards the middle.

To conclude, with this Hydroponic Tower Lid you'll be able to get rid of your top reservoir or water distribution module, and you can also print out tower modules that don't have those center water line holders or water distribution discs/dishes in the center of each module. This gives your plant's roots more space and air flow to grow for faster results!

You'll save time printing new systems, save money on electricity (shorten your on timer!) and water (hits the jackPOT!) as this makes it more efficient and with less printing material needed to use for a complete tower.

Go on, try it out!

Print Settings:

Infill - 5%-10%

Top Layers - 3 Recommended (2 minimum)

Supports - None

Print upside down (full face on bed)