Magentic Chocofi Low Profile High Edges
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a wireless low profile Chocofi case which covers the gaps between the keycap and the plate.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 56
- Makes
- 1
- Views
- 856
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Hello,
This is my first case/ first 3d model I created. I bought a chocofi a while back and was disappointed in the cases available. I wanted something a little more of a case than a cover but keeping the height as low as possible. The case uses a few different size magnets:
- 40 - 5x4mm magnets
- 8 - 5x2mm magnets (display case)
- 8 - 5x5mm magnets (bottom case under display case)
Battery used should be a LP401230 3.7v 105 mAH battery. You will want the cable length to be about 105mm to route all the way to the connector. There is a pathway for the cables to clip into.
Overall the case works. Some parts (display plate) are a bit tricky and need to make sure your printer is really dialed in. Some of the walls around around .3mm, especially around the magnet holes and sloped sides.
Tips: Make sure to check the bridge direction a few areas are pretty long and would recommend an angle of 45 degrees for the top plate.
Any feedback is welcomed and enjoy.