Dell OptiPlex Micro Stand (with PSU Holder)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.06 – €1.30 net (excluding VAT)
For file: dell_optiplex_7080_micro_drill_guide_0.2mm_PLA_MK3S_1h13m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.18 excluding VAT (range midpoint).
- Weight reported by the author
- 14 g
- Print time reported by the author
- 1.22 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A stand to store your Dell OptiPlex Micro vertically, and neatly store your power supply simultaneously!
- Rating
- 0 / 5
- Likes
- 36
- Downloads
- 124
- Makes
- 0
- Views
- 2,444
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
This model is a storage solution for the Dell OptiPlex Micro (pictured is the 7080) PCs, allowing it to stand vertically, and neatly store the PSU and cable. There are accomodations made for the silicone cable strap, so you don't need to cut it off. There is also a storage holder for the plastic pip in the silicone strap. Remove the plastic piece from the strap and clip it into the holder inside the spool.
Print 1 of each STL file. Use M3 threaded inserts (5mm diameter, 4mm deep) and M3x6 machine screws everywhere, except for attaching the foot. Use M3x20 for the inner screws, and M3x10 or M3x12 for the outer screws.
The F360 source file is included in case you want to change the screw sizes or dimensions.
WARNING: This model requires you to drill 5x 3mm holes in the top case. You should use a centre punch to make sure the holes are drilled in the correct places. Put a small book under the top case when hammering so it doesn't get deformed.