1 / 4
Rek5Lab Snap-Fit Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Snap-fit case for the 3x antenna board from Rek5Lab.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 50
- Makes
- 0
- Views
- 416
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This case snaps on to the Rek5Lab 3 antenna board such as the one found here:
https://www.tindie.com/products/rek5lab/flipper-zero-marauder-esp32-cc1101-nrf24l01/
The fit is snug, be careful not to break off fragile components when pressing the board into the case, especially careful of the BOOT & RESET buttons.
The switch is a bit tricky to get into place. I do it with that side of the board popped out just a 1mm or so, fit the hole around the switch, then press in the board.
Print Settings:
- 0.2mm
- No supports
- Optional outer brim