Flash Drive Housing for PNY Attaché
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Flash drive housing. Fits PNY Attaché 64GB USB 3.0 as pictured. Blank top can be customized.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 32
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple housing with side ridges for grip. Flat bottom to stick to the build plate, flat top to be customized as desired. I printed in .12mm layers with a pause at layer 47 to drop the board in and a pause at 61 for a filament swap. It's set as a tight fit and you have to give it some downward force for the flash drive to pop into the partially printed housing.
You may run into an issue if you try to scale it up for a loose fit: There is a column on both sides internally that fit into the notches on the circuit board. There is no play between the housing and the board when printing is complete. Rattly flash drives infuriate me.