Netgear GS108E Friction Wall Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Friction wall mount for the Netgear GS108E gigabit switch.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 1
- Views
- 245
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
A friction wall mount for the Netgear GS108E 8-port switch. Attach the model labeled “SwitchSide” to the switch using 6-8 mm long M3 screws. The cavity on the switch should be deep enough to allow an M3 nut to fit in the wall mount slots. Attach the model named “WallSide” to the wall with #6 or #8 screws. Slide the switch into the wall mount and the grooves will catch. It provides about 10 mm of clearance from the wall.
Prints with no supports. Use your favorite filament. Recommend 0.2 mm layer height or lower. If you want a bit of extra strength on the wall side of the mount, print with 100% infill from 6-10 mm.
The wall mount slots on the GS108E are 4 mm wide and 80 mm center to center. If other switches match this pattern this mount should work for them as well.