Meepo Shuffle V4 Longboard Floor Stand
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€9.36 – €11.44 net (excluding VAT)
For file: LongboardStandMiddle_0.3mm_PETG_MK3S_7h50m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €10.40 excluding VAT (range midpoint).
- Weight reported by the author
- 197 g
- Print time reported by the author
- 7.83 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Allows you to store your Meepo Shuffle V4 in a vertical position wherever you want!
- Rating
- 4.5 / 5
- Likes
- 22
- Downloads
- 117
- Makes
- 2
- Views
- 1,220
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This stand allows you to store your Meepo Shuffle V4 (and possible other longboards) in a vertical position without the need to drill into your wall to install a mount, or even lean it against the wall which could scuff or dirty it.
There are two versions included here. The first is a single file model which will require a printer with a large bed in order to print. The second version is a set of 3 models which can be printed separately and attached together. I designed it to be attached using 4 M8 nuts, 4 M8 bolts (40-45mm long), and 4 washers. Note: if you print this version and wish to attach it with the suggested hardware, you will need to pause the print for the middle piece at the top of the cavity for the nuts (~27.6mm), that way you can insert them before resuming the print.
This stand may work with other longboards as well, but it all depends on the distance between the bottom tip of the board and the bottom of the wheels when it is in an upright position. For the V4, that distance is 29mm.