Timemore Sculptor 78 s Blind Shaker spacer

I made Spacer/Pedestal for Weber Workshops Blind Shaker to reduce coffee grounds falling outside of shaker.

Designed to fit the Timemore Scultor 078 series. (may work for other grinders too)

I had some 3mm x 1,5mm N35 magnets lying around. So I designed the spacer to fit these magnets on the Top and bottom. They can be press fit into bottom of spacer. May require some glue to secure magnets if they pull out depending on your filament and printer calibration. For the bottom magnets i used two 3x1.5 magnets for each hole to add some strength. Please take care of the magnets orientation. I snapped the magnets onto the Sculptor and pushed the model onto it. Worked just fine.

The Spacer snaps into place. With the Blind Shaker it will only align with the Sculptor magnets. I like the top magnets because i can takeout the shaker without spilling the coffee grounds accidentally. (clumsy proof)

I made a clean version without any magnet cutouts. If you like the look or want to remix your own cutouts.

UPDATE (09/2025)

I finally made a version with 12x2 magnet cutouts. This version alligns nicely with the Magnets of the Sculptor78. Even the magnet ontop is helpful to keep everything in place while shaking. 

Dimensions:

Diameter about 8.2 cm

Height about 2 cm (2.7cm incl. back)

Printed in ABS

Wall loops 4

Top/bottom Layer 5

Infill 20 %

Printing Time was 40m on Creality K1

but you can print it as you like :)