Sig P938 single stack 9mm Speed Loader
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
I couldn't find a single stack 9mm speed loader I liked that was compatible with my Sig P938 so I modeled one that I did like. I printed it using fuzzy skin for more grip and a nice look. I used PLA with 50% cubic infill and it seems more than strong enough. If you are going to keep it in a range bag that may see a lot of heat, get left in a car, etc., you may want to use PETG or another heat resistant filament.
I printed this with the base loaded onto the print bed and used organic supports for the pusher that would end up free-floating in air if not supported. Picture included.
Since I am not concerned with perfect esthetics, I printed mine with .6mm nozzle and .3mm layer height. I find these settings to be strong and functional, but not as cosmetically pleasing as a smaller nozzle and reduced layer height. My print time was 1 hour and 49 minutes and used approx. 13.6 meters of 1.75mm filament.