Anycubic i3 Mega Hotend Overhaul
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Upgraded hotend that lets you see the hotend easily, allows adequate cooling of the heatsink, and tidies up wires.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 75
- Makes
- 0
- Views
- 667
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Anycubic i3 Mega Hotend Overhaul
This overhauled hotend housing allows you to see the printhead easily, allows for adequate cooling of the heat sink, hides all of the wires by moving the plugboard behind the x-carriage, and also has a modular part cooling duct that can be changed if you don't like the current design.
All parts shouldn't need too much help from supports. The parts are oriented in the best possible way for printing. Exercise your judgment when adding supports.
---
Foreword:
Make sure you read the directions before you start this project so you know what you're getting in to; some parts of assembly can be very difficult and frustrating. Needlenose pliers and a small mirror may be of great assistance.
This modification will cause the printer's hotend to be a little off center. Remember to add an origin offset of X = -2.6mm and Y = -3mm to re-center all of your prints.
---
Part Checklist
Hardware:
- 1 Anycubic i3 Mega hotend (from the stock build)
- 1 40mm cooling fan (from the stock build)
- The stock part cooling fan (from the stock build)
- The three screws that held the plugboard to the stock shroud (from the stock build)
- 10 M3x16 screws (4 from the stock build)
- 2 M3 nuts (2 from the stock build)
- 2 M3x12 screws
- 10 M3x10 screws
- Misc. parts from the stock build
Plastic Parts:
- 1 of each part in this post (1x ACi3M_Hotend-housing, 1x ACi3M_Belt-block, 1x ACi3M_Plug-mount, 1x ACi3M_Cooling-mount, 1x ACi3M_Cooling-duct-1)