Index knuckles controller grips (without hexagons)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Valve's index controller grips, now easier to print! It shifts your hands, making face buttons easier to press.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 1
- Views
- 79
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A modified version of Valve's index “Knuckles” controller grips, modified to be easier to print on the classic FDM/FFF style 3D printers.
The grips are intended for folks with big hands / long thumbs, to shift the position of your hand downwards, to make the buttons more easily reachable by your thumb. They also make the grips a bit chunkier, which may be easier to hold with long fingers.
I've removed the hexagons from the inner surface of the grips, for printability. I did this by deleting the geometry of the hexagons, leaving the geometry of the original model intact and unmodified. I also did some simple cuts to give it a flat bottom, and no overhangs, without losing its ability to “click” into place.
You'll need to print it with supports enabled, and probably a brim.
The original model was distributed with Creative Commons Attribution-NonCommercial-Sharealike 4.0 International license (http://creativecommons.org/licenses/by-nc-sa/4.0/) so I must do the same.