PRUSA dubbelsided LED bar with filament guide

Hi there

Update: 26-09-2018: (v2)

• Added Filament hole guide, and did some changes to the front, (rounded it off, and made it smaller) Also added printer name to it ;-) Needed some light for my i3 Mk3 printer. and couldnt find anything good. so made this.

  This has a led light bar on each side. No glue, or anything needed, the light bars, just snap into the frame, and stays there. Designed to fit snug, on the Prusa 3d printer frame.

  No filling, or anything needed, just print, and pop the led's in. and fit it to your printer.

  if you need this for another frame, please let me know i will upload it, fitting other sizes

  Used these led bars from ebay: https://www.ebay.com/itm/2PCS-USB-18Led-2W-Office-Table-Lamp-Natural-White-Hand-lamp-Study-light/223101274155?ssPageName=STRK%3AMEBIDX%3AIT&\_trksid=p2057872.m2749.l2649

  and a splitetr like this: https://www.ebay.com/itm/F2AE-USB-Male-To-Dual-Female-Jack-One-Splitter-Two-Power-Data-Cable-Connector/202407998753?ssPageName=STRK%3AMEBIDX%3AIT&\_trksid=p2057872.m2749.l2649

  And if you like an on/off switch for the lights, like this one https://www.ebay.com/itm/USB-Cable-with-On-Off-Switch-Power-Control-for-Raspberry-Pi-Arduino-USB-Toggle/283109084292?hash=item41ea9dcc84:g:oHoAAOSwuTxV9oVT:rk:2:pf:0

  This was made in Fusion 360 (my first project) :-)

  Perhaps in the future i will post a newer version where you can solder the wires together and only have one usb kabel from the frame.

  Best regards

  Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Infill:

20%

Filament: Any PLA Black

Category: 3D Printer Accessories