Milwaukee M12 flashlight with adjustable head
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A flashlight with an adjustable angle head, made from a MR16 led bulb for the Milwaukee M12 battery system.
- Rating
- 0 / 5
- Likes
- 44
- Downloads
- 202
- Makes
- 0
- Views
- 1,755
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a flashlight for Milwaukee M12 battery. It has a head with an adjustable angle, made from MR16 led bulb.
BOM
To assembly it, you will need:
- 3d printed lamp head.
- 3d printed upper piece of the body.
- 3d printed lower piece of the body.
- 3-5W MR16 led bulb with a radiator with M28x1 thread (see photos)
- 2x 8mm length M3 screw
- 3x 16mm length M3 screw
- 2 pieces of 6.3mm spade male connectors
- 1 piece of 21x15mm rocker on/off switch
- 10cm of 2-wire cable
soldering iron Notes
My led bulb uses almost 5 Watts and gets really hot (over 60°C) so printing lamp head with plain PLA may be not enough. I used PETG and it is holding ok. PLA could be probably used after "baking".
There seems to be a lot of MR16 led bulbs with M28x1 thread on aliexpress. I checked MR16 bulb from this page and it fits the thread perfectly. Bear in mind that power of those bulb is greatly exaggerated, 9W bulb in reality draws around 3W.
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
25%
Notes:
Support is needed but it is very easy to remove it with long pliers, and almost all surfaces touching support are invisible after the assembly.
I used X-Acto knife to fix cuts around four locking pins in the lamp head part to ensure that all four locking pins are working as springs.