Celeste's 10" rackmount panel V.1 for TL-SG108
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This sturdy 1U mounting panel for 10 inch server racks fits one TP-Link TL-SG108 8-port, 1G, consumer network switch.
- Rating
- 5 / 5
- Likes
- 114
- Downloads
- 772
- Makes
- 8
- Views
- 5,339
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- GNU General Public License v3.0
-------------------------------------------------------------------------------------------------
UPGRADED PARTS AVAILABLE!
-------------------------------------------------------------------------------------------------
This sturdy 1U mounting panel for 10 inch server racks fits one TP-Link TL-SG108 8-port, 1G, consumer network switch.
It's designed to have minimum flex while also using little material, so the front of your rack can be supported or even held together with these panels only.
Mounts with regular M6 cage nuts, rack studs, etc.
Material | PETG, ABS |
Layer height | .2mm or any |
Raft | nope |
Supports | nope |
Infill | 20%, gyroid |
Print surface | powder-coated steel for nice finish ;) |
Your switch should fit into it and stay in place due to friction only (tho your mileage may vary). If the part is to large, add some tape to your switch to make it fit. If the part turns out to be too small, which is highly unlikely, print it again with about +0.5% (at most +1%) scaling. This should be more then enough.