1 / 6
Voron Bowden ptfe tube guide arm and canbus cable support — image 1
1 / 6

Voron Bowden ptfe tube guide arm and canbus cable support

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Voron PTFE Bowden tube guide and canbus cable holder

Rating
4.909 / 5
Likes
686
Downloads
13,610
Makes
36
Views
29,621
Reviews
33

Updated at source:

Model information

License
GNU General Public License v3.0

V2- PTFE bowden tube guide and CANBUS wire support

 

**** 7NOV24 -Removed a zip tie hole on the long arm's that was a weak point ****

 

I've made some adjustment after some feedback from the community.

Changes made over V1:

  • Added a option to have F695 bearings incorporated 

  • Enlarged the tube opening

  • Added cable/zip tie openings 

  • Added spot for 1mm piano wire if needed.

 

Recommended print settings:

  • Voron print settings (4 walls, 40% infill and 5 top and bottom layers)

  • Turn off thin walls

  • Bridge setting: keep only bridges (watch out for bridging for cable tie holes)

  • 0.2mm layers and 0.2mm first layer

  • No need to adjust for ABS shrinkage 

 

Required Hardware:

  • M3x8 Bolt and M3 T-nut

  • M5 bolt to suit option.

  • Optional M5 nut if you can fit it with the bearing option.

 

V1 - PTFE bowden tube guide and CANBUS wire support

This is can found inside the zip files and of the initial release

Required Hardware:

  • M3x8 Bolt and M3 T-nut

  • M5x10 Bolt or a M5x8/12

  • Optional 4mm drill bit for cleaning out bowden tube path

About

In my 350 build the PTFE tube kept getting caught so I made this arm to keep it up. The shorter arm works better so I recommend using it instead
The setup has also been used by a few user to support their CANBUS wires (zip tied to the reverse bowden)

Install

  • Drill out bowden guide with 4mm drill bit for a perfect fit (optional)

  • Bolt mount to rear frame with M3x8 and tnut putting the lip at the top

  • Screw arm on with M5x10 (I used a M5x8mm and it works fine) into the plastic allowing the arm to still be able to swivel

Tags