1 / 8
V3 Hitchhikers Guide Magnetic cover plate set for V3 270 degree hinge — image 1
1 / 8

V3 Hitchhikers Guide Magnetic cover plate set for V3 270 degree hinge

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Magnetic cover plate set for version 3 of my 270 degree hinge for K series printers

Rating
0 / 5
Likes
5
Downloads
39
Makes
0
Views
233
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

A set of quick change cover plates for my 3rd version of the K1 series 270 degree hinges. These are designed solely for use on V3 and will not fit the earlier versions.

The two smaller hinge face plates require a total of four 5x1mm magnets (2 per plate).

The larger side hinge face plates requires a total of six 5x1mm magnets (3 per plate).

I previously started down the face plate path with version 2 of my hinge. But to change the plates on V2 meant removing the hinge screws to swap a set over. Version 3 uses magnets for the plates instead. So on version 3, if you fancy a different look, you can instantly slide the current plates off and drop a different set in their place.

I had initially completed and uploaded around six of the eleven sets I had intended doing for the V2 Hinge. 

At the time of uploading the version 3 magnetic hinge I only have a few sets fully completed. I plan to get to work on recreating and uploading the currently released V2 sets in Magnetic V3 form this week. If you want a particular one of those from the V2 sets in V3 form bumped up the list, leave me a message. It doesn't matter to me what order I do them in so I am happy to prioritise any that users might want sooner rather than later.

My demo test pieces were done at fat layer heights. I advise printing them at low layer heights for better quality. Strength of the part doesn't matter as there are no stresses involved in their use.

Note:- K1C and some new K1 printers that come with a K1C enclosure cannot use the V3 side hinge portion (the k1c adapter is too small to do anything worthwhile and was only created so K1C case owners could fit the 270 hinges). Only the front panel covers are available to K1C case owners.

There is now another Hitchhikers inspired upload. A K1/K1C/K1 Max screen protection cover. Available here :- Hitchhikers K1 Series Screen protection cover

Tags