Tube Cutter for water filter tubing (3/8", 1/4", & PTFE)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.27 – €1.56 net (excluding VAT)
For file: both-v9_0.6n_0.2mm_PETG_MK4IS_55m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.41 excluding VAT (range midpoint).
- Weight reported by the author
- 30 g
- Print time reported by the author
- 55.2 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Cut 3/8”, ¼”, and PTFE tubing.
- Rating
- 5 / 5
- Likes
- 39
- Downloads
- 202
- Makes
- 4
- Views
- 995
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This cutter is easy to print, easy to assemble, and easy to use. It cuts 3 sizes of tubing:
- 3/8” (9.525mm) used in RO water systems
- ¼” (6.35mm) used in RO water systems
- PTFE (4mm)
Parts Needed
- 1 single edged razor blade
- 1 M3x20 screw
- 1 M3 self-locking hex nut
- 2 M3x8 screws
- 2 M3 hex nuts
Assembly
- Slide the razor blade in from the end until the holes line up.
- Fasten with M3x8 or 10 screws and hex nuts. Note that one side has a round recess for the screw head and the other side has a hex recess for the nut. Tighten snugly to keep the blade from moving.
- Slide the upper and lower plastic parts together so the hinge holes line up.
- Fasten with M3x10 screw and self-locking nut. Note the round and hex recesses. Tighten enough to keep it from loosening up, but not so tight that it pinches and prevents the hinge from moving easily. (I prefer the self-locking nut for this, but you may substitute a non-self-locking nut; although it may loosen up with use.)
Usage
Slide the tube to be cut in from either side. The tubing hole is open on the top so you may easily see where the cut will be made.
The extra “fin” on the upper part slides into the slot on the lower part to guarantee good blade alignment into its cutting slot.
Printing
There are no special requirements. Use any filament. Needs no support. Standard settings are OK. I used a .6 nozzle, .20 layer height, 20% grid infill.