Counting matching models…
The original caps got lost during tyre change, so I've made a replacement. This is 60mm version of the caps. The exact size is 59.8mm to allow for tiny clearance. I've printed it using PETG which is flexible enough to click in without…
I needed a simple table to help my kids to learn multiplication. Sure. You can just print it on a paper, but what a nerd would I be. So i've made a 3d-printed one. Print instructions Material: Any (PETG in my case) Resolution: 0.2mm…
Printed in a generic white PETG - 0.2mm layer height Small changes to open the lid easier and changed size from the original. I've also added the fuzzy skin (in PrusaSlicer) to make it less slippery. Enjoy :)
Quick and easy Voltage Regulator Enclosure. The voltage regulator: XL4015 DC-DC or similar. Internal dimensions: 50 x 22 x 18mm External dimensions: 63 x 25 x 23.7mm Material: Prusament PETG Layer height: 0.24 Nozzle: 0.6mm Alternative:…
I liked the https://www.printables.com/@Satellietje model, but I needed to keep more bits with the screwdriver, so I created similar stand in that way. The screwdriver has bits with diameter of 8mm hexagon (standard is something like…
I needed some organizer for a lot of screws and I liked hexagonal ones posted around on this site and/or thingiverse. Unfortunately they were mostly too small for my needs, so I designed my own. As you can see in photos it can hold quite…
Ikea changed the slider's dimensions so you are forced to buy whole set. No way! Here is a solution :) Printed by 50 pieces at once with no problem, but you will need good print plate adhesion. 0.4mm nozzle 0.2 layer height PETG
Printed in PETG and fits fine, looks durable. This is a remix of https://www.thingiverse.com/thing:4942631
square bits sizes are: 4.8 (5mm hole) 5.8 (6mm hole) 6.8 (7mm hole) I've printed it using Prusament ASA, 0.2mm layer height, 50% infill
I needed a bowl under my new flowerpot. This way was faster then driving to a shop. Printed in Prusament ASA. 5 degrees higher nozzle temp for better layer adhesion. 50% infill 3 perimeters Enjoy :)
Printed in GREEN PETG, with two colour changes. the first change at the layer immediately after plate to BLACK. the second change after eyebrows layer finishes to WHITE. Then carefully heated it over the flame and bent it slightly. At the…
This is a holder for my 30mm diameter star finder which I needed to fit to my new telescope's slider. It's inspired by https://www.printables.com/model/165854-astronomy-mounting-bracket-for-laser-pointer holder which was just too small…
You can find here 2 holes and 3 holes versions of the holder for TP-Link TL-SG108, 8port switch. I used PETG, 0.2mm with no issues. Enjoy
In order to block as much as possible ambient light from surrounding civilization I've designed this Ambient Light Protector for my Levenhuk Ra 150C Cassegrain telescope. It's push to fit design. Also the original cover fits well when you…
I did not like the original enclosure STL, so I designed a new one. https://www.laskakit.cz/laskakit-espink-42-esp32-e-paper-pcb-antenna/?variantId=13538 It uses two strong magnets glued into the back side of front panel which holds it…
These are all currently available results.
