P
Printablesungineering
Milwaukee M12 Fuel Drill bit holder
The bit holder slips on the drill, no screws or modifications to the drill required. It'll work with or without the belt clip.
- Downloads
- 641
- Likes
- 117
- Rating
- 5
All models
Counting matching models…
P
Printablesungineering
Fluke 101 multimeter stand
This is a much improved model over my previous attempt. The stand only requires support at the back where the cable pocket is (although you can try without support if you're feeling brave). Material: PLA (uses about 65g at 20% infill)…
- Downloads
- 106
- Likes
- 18
- Rating
- 5
P
Printablesungineering
Thermal Master P2 Pro insert for rugged box
This is an insert for the rugged box to hold the Thermal Master P2 Pro camera for iPhone; it might also fit the android version, but I don't have one, so I can't test it. To enhance the functionality, you can place magnets under the…
- Downloads
- 95
- Likes
- 9
- Rating
- 0
P
Printablesungineering
Fluke 101 multimeter stand
NB: The two sides are different (the pegs are off-centre), don't mix them up! The stand can be printed at once or in parts and assembled. I printed it in PETG, but it can be printed in PLA or ABS. Uses about 40g of filament at 20% infill.…
- Downloads
- 73
- Likes
- 9
- Rating
- 0
P
Printablesungineering
Anker Prime Charger Holder Stand
This is perfect for desktop use if you need easy access to all the cables. It fits the charger snugly. Feed the cable through the back first and insert into the charger before sliding the charger in. A wide base prevents it from tipping…
- Downloads
- 63
- Likes
- 10
- Rating
- 5
P
Printablesungineering
Magnetic tips holder for Atten ST-862D rework station
It sticks very well to the station even with 4 magnets (out of available 8 spots). Material: PLA or PETG (uses about 17g) Layer height: 0.12mm Wall loops: 2 Supports: No Infill: 15% (lightning)
- Downloads
- 47
- Likes
- 6
- Rating
- 5
P
Printablesungineering
Updated Fluke 101 multimeter stand
I can't help myself, I'm addicted to making Fluke 101 Multimeter stands and I haven't been able to find a support group for that yet. This is an even better model of my previous multimeter stand This stand integrates probe holders into…
- Downloads
- 35
- Likes
- 5
- Rating
- 0
P
Printablesungineering
Sharpal 8x3 diamond sharpener base
I could not find an “open” model, so I made my own. It fits the stone snugly, no wiggle room. I also made a cutout for the blade angle guide, although anything over 0.1mm layer height makes it ugly. Material: any Uses just under 100g of…
- Downloads
- 14
- Likes
- 0
- Rating
- 0
These are all currently available results.