Counting matching models…
This is Yorkshire Terrier model has room for a small plant as well as drainage holes for watering. This model is a remix of the Dog Low poly york on Thingiverse by fokuspace . To make the holes in the model for the plant and drainage, I…
A screw sizing gauge for all standard imperial size screws (at least all the ones in the McMaster-Carr Catalog) as shown below. The sides are angled and slotted to make it very easy to align and determine the length of screws/bolts with…
This is a two-textured pot made up of two intersecting models: a model for the top, bottom and spiral stripes which I printed with side perimeters, and a model for the sweeping sides of the pot, which I printed with gyroid infill but no…
I needed to test a filament which has a higher specified temperature range than the available temperature towers, so I used Parametric temperature & bridging tower + G-Code generator to create a custom temperature tower that went up to my…
This digital caliper holder stays securely attached to your pegboard thanks to two hooks which hold the bottom and prevent the holder from flipping up when you remove it. These hooks flex into the bottom pegboard holes. To insert or…
My local bike trails are pretty rough, so I decided to print myself some custom handle bar grips out of TPU that offer some extra padding. The grips fit a standard 7/8" handle bar, and are sized such that 10% gyroid infill will form a…
This is an extremely quick model for holding 3 bits for a standard hex driver, which I made to hold a loose set of counter-sink bits from Harbor Freight. I deliberately made the fit tight, so you may need to file the insides down to hold…
Having misplaced the camera mounting plate for my NEEWER Tripod ( Amazon link ), I printed an extremely simple little mounting plate, which uses a ¼ x 20 bolt to attach the camera.
This model allows the mounting of a 1" pipe clamp securely onto a peg board. The pegboard hooks distribute the weight of the clamp over pegboard holes, while featuring a retaining hook to keep the clamp from flipping up. In order to…
Make use of the spare belt clip spot on your driver by holding a couple of your most used driver bits. This model is sized to fit in the belt clip slot, and uses a 5/8" #8-32 screw to attach securely to the drill. Each hex hole has a nub…
Be Warned: I'm neither a motorcycle mechanic nor an electrician, so modify your bike's electronics at your own risk! This is an alternative to the stock fuse cover for the Triumph Bonneville provides the extra height and wire-out hole…
This is a replacement fuse cover for a 2011 Triumph Bonneville T100, which is the same size and shape as the original, and is held in place with the original tabs. It should probably fit any EFI T100 or SE, but it might work on other…
Come with everything, but are too useful to throw away. This stackable Gridfinity tray sorts and organizes the most common short lengths of wire ties, so they're close to hand whenever you need one. It also features slots of various…
This is a simple cash separator which helps you keep the denominations of cash organized, separated, and easy to find. Here are a few useful features: Separates the following cash denominations $20, $10, $5, $1 Labels and arrows on each…
This simple remix of the Prusa Enclosure Door Knob's latch allows you to mount a Logitech C270 webcam (or any webcam with a 7.1mm rotation shaft) behind your latch for nice overview shots of your print bed. The only hardware required is…
This is a simple replacement for the knob connecting the swiffer handle to the sheet holder. It has a basic STL file version with the original shape, and a 3MF version that also has a modifier that can be used to increase the perimeters…
These are all currently available results.
