Counting matching models…
Replacement gear for BMW R1150GS speedometer drive - BMW RealOEM number 62122306287. There is probably no official replacement part of the plastic drive, so I took the original one and re-modeled it. Please note that dimensions of the…
Locking device to lock clutch housing, used on BMW R1150 motorcycles. BMW part number - 11 5 640. Printed in 100% infill with PETG. Works and holds perfectly, even with those five 40Nm and 32° torque settings for flywheel bolts.
Simple mix of two great systems - RepRack and Honeycomb Storage Wall. I have RepRack next to my printer and the area of the RepRack hanger was bit unused and HSW was the best choice to adapt these two systems. Original HSW Base is 8mm…
Extension for hand-guards on R1150 GS/A and similar ones (R1200 GS should have the same shape, but not tested). Extensions is made in two variants: Connection to hand-guard with M4x12 bolts and nuts (ideally with some button flange head…
Bracket to hold bar for your navigation or phone on BMW R1150 GS motorcycle. Important note : This bracket is made for -street- use. If your navigation / phone is heavy and you will be riding a lot of offroad-ing, the vibrations of…
Gimbal from Martin_au is really nice model, but few parts are made with imperial parts, thus really hard or expensive to obtain in Europe. I replaced the thrust bearing with more common one in Europe - 51100 (with dimensions 10x24x9) and…
Little cute capybara made from cubes and magnets. You will just need 10x5 magnets and if my math is bad, you will need 72 of those . It is press fit, but based on filament you will print it in, it might meed some super glue to hold it in…
Holder for the most common thermometers you can find on Aliexpress and similar web-shops - rectangle with sensor on wire and round one with moisture indicator. I created three versions: Round one - 42 mm dia, 14 mm deep - created as first…
Simple box to give an access to power switch of the 3d printer from the front side. I wanted to use some standardised components and not to solder and cut too many wires and have mess underneath the table. This box uses three components:…
Simple model of Rudolph the Red-Nosed Reindeer, which can be easily disassembled as the original design is made by friend of mine, who cut it from the wood several decades back. I made my own version of Rudolph years ago from the wood,…
These are all currently available results.
