Counting matching models…
I printed this on its back with lots of support, which left it a bit ugly, but I did not have a better idea. Had to clean up the back of the part with a file before the T-Clip would engage.
Just a simple one-piece holder for a single pound coin, to go on your keyring. Plus a pound-sized cylinder.
This is a clip to attach 1/4 drive sockets to the socket rail in a Wera Tool-Check Mini (from the 2024 advent calendar). This comes with 3 sockets but has a rail long enough for 5. I use a lot of M4 and M3 so I want 7 and 5.5mm sockets.…
Some designs using this: https://www.printables.com/model/695410-cutter-holder-for-skadis-t-clip https://www.printables.com/model/695385-parametric-tray-for-t-clip-with-locating-pins…
If you have a SureFeed MPF001 and it runs its motor but can't lift its lid, you may need this part. Or maybe https://www.printables.com/model/209284-surefeed-mpf001-lid-opener-repair-part Open it up and take a look. I replaced the short…
Lasercut (from 3mm acrylic) panel is Skadis-compatible, albeit a bit thinner. I used 3mm acrylic. Mounting spacers are printed, and secured to the Bambu with 3M VHB double-sided tape. You need 4 M3 square nuts and 8mm bolts to attach the…
This is a parametric tray for the T-Clip system, using a modified T-Clip socket that locates to the SKADIS slot
This is a parametric tray with lid for the T-Clip system, using a modified T-Clip socket
Let me know if you need other sizes and don't have Fusion to make them.
This is a little tambour-door storage compartment to put in the spare space in your Eurorack. Keep your patch leads or knurlies or smaller snacks in it. I'd be delighted to hear what you use it for. 8hp and 16hp variations are here, but…
Dunnage bags are usually inflated with an adapter that take high-pressure air from a compressor and converts it to high-volume low-pressure air. This adapter is useful when you have a supply of low-pressure high-volume air (eg from a…
This is an easy-to-use latch to retain Hexpansions in your Tildagon without needing to wrangle tiny bolts. It needs 3 dowel pins, 8mm long and 1.5mm diameter, which pushfit into holes. The bottom two should stick out by 2mm, enough to go…
This clips into a Tildagon (2026 version) to hold a hexpansion down against the soldered-on M2 nuts. Use this in conjunction with a couple of M2x8 bolts screwed in from the bottom of the Tildagon to secure the hexpansion against sliding…
This is a holder to add space for the 711L 4mm ratchet and a short 4mm extension to any Wera Tool-Check. It's most useful with the Modular Micro 1. The ratchet comes in 2 versions, this is for the knurled version. I don't know if the…
These are all currently available results.
