Counting matching models…
I made a more sturdier new Version 2 which can be found her: New Version 2: Replacement fix for BOSCH fridge door tray 00705901 // Ersatzteil Bosch Kühlschrank Türfach I'll leave the old version here since it uses very little filament:…
To install the fanless HP640 I chose a vertical position with spacers for best heat transfer. On this thin client I run a home assistant server very powerconsumption-effective. The spacers are split from the baseplate for better…
The mounting of the door tray failed on my BOSCH fridge. So here is a little Model to fix the broken mounting. This is a improved -more sturdier- Version 2. Printed with Prusament PETG Urban Grey . The print in the picture is from a MK4S…
The part follows the profile of the cracked fridge crisperbox drawer. The printed model is superglued on the crack. Make sure to apply superglue before putting the model on the crack. I also put a little superglue on the crack itself.…
I secured my bags against movement with these tension belt mounts. Tested on a 3 week offroad morocco trip without any issues. The outer diameter of the crashbar is 20,3 mm (0.8 inches). The screws used are M6x20 and a locknut. I…
Holder for a tedeligo remote control. To get the remote out of the holder you can push the keyholder up. Printed in PETG; Nozzle 0,4mm; 0,2mmlayer hight; 5 layers wall, bottom, top; 25%infill; support everywhere. Printed flat to get the…
Secures a 13mm tube. The tube will not slip out. I used the model to securely route a gardena microdrip 13mm (innerdiameter) from my terrace one floor down. It uses four m4 screws with hexagon nuts and two countersunk wood screws. Use at…
I used this model to secure the routing of a Gardena 13mm (innerdiameter) tube. The holder is attached with double-sided adhesive tape (width 19mm) and the tube is attached with two zipties (width 4,8mm). Use at your own risk. This 3D…
While overhauling the engine on the bench it's necessary to turn the engine. The length is designed that the rotor nut gives tension to the hextube so the slot for the Woodruff key does not take the load alone. I made two versions: Heavy…
These are all currently available results.
