Counting matching models…
A box/holder for your SD cards! It holds up to 12 microSD cards and 3 full-size SD cards. It also has an integrated lid connected via a print-in-place linkage, which latches securely shut to ensure your SD cards won't fall out on the go.…
This is a rail to mount 3.5" disk drives in the drive cage of Cooler Master PC cases. It's designed such that it just uses pegs to hold the drives, in case you don't happen to have HDD screws on hand. Prints in one piece. The only place…
My original stand for my die-cast model of the U.S.S. Enterprise NCC-1701-D shattered due to a fall, so I made a replacement. This one is a single piece, and the base is fashioned in the shape of the combadge from the show. Specifically,…
Stud earrings in the shape of 2mg estradiol tablets - the icon of the transfem community. Both small and large variants are included. The small ones are 1.5x the size of the actual tablets (the smallest possible size that will accommodate…
I was tired of finding desiccant pellets embedded in my filament spools, so I designed this. It fits loosely in the bottom of a 5 gallon bucket (commonly used as a DIY drybox) and provides ~40mm of clearance for desiccant below your…
Designed to nestle into the crooks at the far left and right sides of the wings. Uses two Small-size command strips for wall mounting, one for each side. Prints in the provided orientation (flat wall-mount side facing down). Minimal…
A simple magnetic holder for an Expo dry-erase eraser, perfect for sticking to a fridge or whiteboard. Requires two neodymium disc magnets, either 6x3mm or 8x3mm. This design uses embedded magnets. To set this up, in your slicer, insert a…
When I visited Disney World in Orlando, FL, one of the only souvenirs I got was a die-cast model of the Milano from the Guardians of the Galaxy: Cosmic Rewind attraction at EPCOT. While the model itself is well-made, unfortunately the…
A simple replacement for the battery cover on the GMC-320S geiger counter. Has a somewhat steep 60 degree overhang, but is printable without supports otherwise. I used white Overture PLA.
A very simple replacement cap for the MobileLite Duo flash drive / card reader. Printable without supports or any other special print instructions. I used black Overture PLA, but anything should do.
These are all currently available results.
