Counting matching models…
I wasn't satisfied with many of the safety razor disposal banks on here. So I made my own. Mainly I thought that most of the boxes are too big, since a hundred blades will take years to get through and fits in the space of a couple dozen…
Reccomend printing with organic supports at 0.2 layer height with 0.4 nozzle. If you want the same fuzzy skin texture for the grip and the logo on the back like in the picture then try using the .3mf file below, though bare in mind this…
If you like, you can also peel the label off the original knob and stick it onto the replacement, as seen in the photo above
Yeah this is probably quite odd, but if you have an 8BitDo Micro then you may not have tried using it vertically in one hand. It turns out, at least for me, that I can reach almost all the buttons on the controller when I hold it like…
A remix of Candice's Vertical stand, adding more support, fillets, and a logo. I sometimes like to play my steam deck with a controller lying in bed, with the deck propped up vertically on my nightstand. This is the perfect stand for such…
The Anker PowerCore Essential 20K battery bank isn't really powerful enough to charger the deck while you play, but it's the battery bank I have, so I wanted to make a clip to hold it. You can buy the same model here:…
Reccomend printing in PETG with supports on the build-plate only. If the print fails, try printing each part seperately, and rotating the bottom 90 degrees on the x axis, printing the topscrew at the angle it comes in, and the handle as…
A paper towel or shop twoel holder that can be printed as tall as needed, in roughly 150mm incraments. You can glue and pin the segments using dowels of 1.7mm filament. I reccomend printing the mid and top sections horizonally for best…
Printing may require some light internal supports. They can be a bit of a nuicance to remove, but it's ok. Fitting the tape dispenser into the reinforcement shell is also quite a tight fit and requires maneouvering the two parts inside of…
These are all currently available results.
![Scotch Tape Dispenser Stiffener for 0.75 inch tape (Magic brand UK/EU product) [19 mm]](https://media.printables.com/media/prints/759128/images/5919321_02332be6-152e-4fbd-adf5-1160dfcc776b_16fc27b0-6883-435b-a695-fb3e6ac5c414/20240210_130423.jpg)