Counting matching models…
This helps to divide compartmets in Qbrick system two organizer MULTI into smaller boxes. Original box (organizer) has three different sized compartments (see image below). For each compartment there is folder containing .stl files for…
This is remix of insert for awesome TS100 pinecil case. https://www.printables.com/model/345083-rugged-multipart-pinecilts100ts80-case-v2 This remix has place for 5 ml syringe with flux. Outer diameter of syringe is 13.7 mm, maximum…
I need cup for my flux so I created one. This is designed for cartrige with "Future rework jelly" from Elchemco company. Inner diameter of cap on open end is 10.55 mm. Recommended to print standing with brim.
This is replacement for curtain hooks for “rail” pelmet.
This is holder for i-tec 10 port USB hub. For complete assembly is needed: 1x wall mount (printed) 1x end cap (printed) 2x M3 thread inserter 2x M3x10 bolt wall plugs and screws Assembly instructions: 1) Print both parts (wall mount and…
Cover/blinder for Xiaomi camera 360°. Camera is mounted in base part and if needed it can be covered by screwable cover. 3D printed parts: Base part: layer height: 0.2 mm supports: optional (recommended for USB connector opening) File…
Sunblinds cover. The original one broke over time so i decided make my own. For one window one left and one right cover is needed. Files: BlindsCover_right.stl Cover for right side BlindsCover_left.stl Cover for left side…
Model is used as casing/housing for female coaxial power connector/barel jack connector (panel mount type). On one side of the housing there is hole for connector mentioned above (diameter 8 mm). On other side of the housing there is…
This is protective case for wire brush used with drill. Reason is not protect wire brush itself but protect everything around (including humans) not to get scratch. Design consists of two parts - body and lid which will screw together.…
Modification of this awesome housing from @VladimirWaas_694872 for air quality sensor to accommodate additional sensors and external antenna. Designed to fit Laskakit I2C sensor board with breakout sensor part with 2x2 pin header…
These are all currently available results.
