Counting matching models…
Sometimes it's necessary to solder wires directly to LED stripes instead of using connector plugs. I'm using this tools especially to make connections if I use the LED stripes in wet or damp environments to prevent the contacts from…
XT60/XT90 connectors are often used from model builders to connect LiPo batteries to the receiver system, electric engines or the control units and starter motors of jet-engines. With this tool the wires are aligned with the connectors…
Soldering tool for cable in cases when there isn't enough space to use a ‘flexible help (third hand)’. Initially that tool has been developed for usage in model-airplanes (for example to repair a defect servo cable) but it's also useful…
This model is an ejection seat for the L-39 Albatros jet from customwings.cz in scale 1:3.5. The seat's size had to be adjusted a little bit to fit into the cockpit of the customwings model because the cockpit is a little bit smaller as…
Soldering tool for cabel in case there isn't enough space to use a 'flexible help (third hand)'. Initially that tool has been developed for usage in model-airplanes (for example to repair a defect servo cable) but it's also useful for…
In jet models Festo ball-valves are often used to cut-off the fuel pipe to the turbine after landing or during the refuel prozess to prevent the turbine from flooding with kerosene. In large model aircrafts above 25 kg takeoff weight…
This model is a modiefied version of my earlier posted ejction-seat for L-39 Albatros jet from customwings.cz. This new version is an unmodified scale 1:3.5 seat and I don't use any screws in this version to make it easier to change the…
NACA air intakes for the L-39 Albatros in different sizes. There are two different assembly variations. The version shown in picture one is used when the installation to the fuselage is only accessible from the outside. In that case you…
A simple tray to put your Sodastream glassbottle into your fridge in case there isn't enough space to set it upright but you don't like it to roll around. I'm printing this with PETG, 0.20 mm layer hight and 40% infill.
Clamp for 3, 4 and 6 mm PUN Tubes, also useful to secure receiver antenna cable.
This is a scale 1:3.5 side-rudder antenna model (with holes for 2.4 GHz antennas) for the L-39 Albatros. Part 3 provides enough material to sand it to fit it to the profile bulge of the fin. Part 2 is meant to add more stability and…
In jet models Festo ball-valves are often used to cut-off the fuel pipe to the turbine after landing or during the refuel prozess to prevent the turbine from flooding with kerosene. Some ppl prefer to cut-off the refuel pipe with a…
This is a decoy flare launching platform for an L-39 Albatros jet scale 1:3.5. For easy integration into the fuselage it's made of two parts. On the original L-39 Albatros it's mostly installed on the right side of the fuselage at the…
Case for a Raspberry PI 4B with an integrated 4" Touchscreen and a GPIO Edge Connector. All parts are printed with PETG. Layer hight: 0,2mm Infill: 20 %, cubic and monotonic Additional Material: 4 M2x20mm countersunk screws 4 M2x14mm…
These are all currently available results.
