Counting matching models…
This is a QuinLED Dig-Quad case / enclosure remixed from https://www.printables.com/model/223377-quinled-dig-quad-v3-case. with some changes: Much smaller footprint without extra room inside. External antenna mount hole on side and lid.…
A bracket to mount the TP-Link TP-SG108 switch under a table or desk. Use 4 x #8 wood screws. Switch is held into place using bumps on the bracket that fit into the existing switch mounting slots.
Printed at 0.2mm layer height. Nozzle 0.4mm. No supports needed. But brim helpful since it is thin. Bracket in photos was printed in white PLA. The source is here at Onshape if you would like to make a remix with source.
This is a battery bracket for RAK Unify 150x100x45 enclosure plate . It allows you to fit 3 cell 18650 battery packs like the Adafruit 6600mAh 18650 pack . Print settings I used on my MK4 with 0.4mm nozzle: Print in PETG or ASA if using…
This is a remix of the Home Assistant Yellow enclosure with the mounting flanges. You can use some #6 wood screws to mount it to a desk, table, or something flat and easily screwed into. The source is at…
The Austec is a case for the Heltec T114 designed with help from Austin Mesh members. It can take the Gizont or GT-800 antenna and fits a 103450 (or similar sized) LiPo cell battery. See the article that pairs with this case at…
Capacity Notes I don't recommend running using this configuration in its current form. The capacity of 3Ah cells in the BCPB2 is only enough to run the G2 for about 3 days without sunlight. If this is acceptable to you then feel free to…
A KLIPPT base for a #8 countersunk screw instead of the default M4 screw.
About I'm calling this the RAKshare. A bracket for the RAK Unify 180x130x60mm enclosure to mount: RAK 1W booster 19007 / 3401 / 13302 board. Waveshare Solar Power Manager (D). Adafruit INA3221 STEMMA QT board for power monitoring.…
I was having some difficulty aligning my KLIPPT bases while screwing them down into my desk. I thought it might be helpful to make a tool to keep it aligned while screwing it down. It definitely helps a bit more than trying to hold your…
This is a simple molle clip I made for the Nitecore NU05 V2. The clip on the light kept popping off my backpack. I made this to stay clipped on much better. Print in PETG so it has some flex without breaking while you attach it to molle…
These are all currently available results.
