Counting matching models…
A simple but very sturdy wall mount for a FS91 and FS31 trimmer. It may fit other models as well with the same injection molded part around the upper driveshaft. I modeled this around my specific machine and you may need to scale it up to…
Simple container that holds one box of rifle ammunition. There are standoffs in the bottom of the case to protect ballistic tips. UPDATE: v6 fixes the grip sketch that becomes unconstrained when changing parameters. Print Settings These…
Add supports under the corners of the semicircle cut outs. On the first print I had supports under the arch as well, but subsequent prints proved it was not required. The .3mf file has supports already painted on.
A remix of: https://www.thingiverse.com/thing:4189133 I added a dovetail mount that screws to the wall. The hanger then slides over that, hiding the screws. PRINT AS SHOWN IN THE .3MF FILE. It also has the infill, perimeters, and seam…
Update 11/3/23: Added a slot for a Logitech wireless mouse/keyboard USB dongle: “X1C Cable Reel with USB.3mf” Original: Cable management spool for a Lenovo 65W charger that came with a Think Pad X1 Carbon Gen10. I would bet that Lenovo…
Hanger for Kitchenaid tools that clamps and slides on a wire shelf. Used the hanger design from iplop: https://www.printables.com/model/137344-kitchenaid-attachment-hanger The shelf I own is pretty common in the USA. It has 3mm wire every…
I hated having to reach down to the floor to grab my phone charger's cable every night. This keeps it handy at the top of my nightstand. This is meant to be semi-permanent, once the dovetail slides together the interference between layer…
Easy storage and access to chuck key. This version is meant to have a disc magnet mounted it for easy placement. Fusion360 file is attached for easy customization.
Change gears for Emco Super 11. There is also a stand for storage. Here are the print parameters I used, change as you see fit. I printed them one at a time to avoid any stringing/blobs on the outside of the gears. PLA 5 perimeters 30%…
Replacement slide stopper for the 505 series dial caliper. Might work on others too. Prints in about 3 minutes. Its a bit short between pins, but it helps hold it in tight.
Feet to lift the laptop and improve cooling. The rubber feet on the laptop sit in the groves and help keep the feet in place. I think the angle is ~5 degrees.
Snap in T slot covers for the cross slide. Cut to desired length. Fusion360 file included if you want to modify. Print upside down as shown in photo.
These are all currently available results.
