Counting matching models…
This battery box was designed to replace the sealed lead acid battery in my APC UPS. The runtime is multiplied with this battery. If it is possible, you need to set the float charging voltage of the UPS to maximum 13,6V to not stress the…
You need 4pcs M3x6 countersunk screw to fit the drive in the caddy. Tested servers: FUJITSU Server PRIMERGY TX120 S3 SFF FUJITSU Server PRIMERGY RX100 S8 rack server FUJITSU Server PRIMERGY RX1330 M1 rack server FUJITSU Server PRIMERGY…
Nozzle: 0.4mm Layer height: 0.2mm Infill: 100% Perimeters: 3 Supports: no 50x19mm board: 12V PWM 4 Wire Temperature Speed Controller Governor Module Temperature RPM LED Display Cooling Fan Control Switch (3P Plug Cable):…
Nozzle: 0.4mm Layer height: 0.2mm Material: PETG Supports only needed for 2.5 drives. Screws: 4pcs 6-32x6mm countresunk screw for 3.5" drives. 4pcs M3*5mm countersunk screws for 2.5" drives. You can print in place. After the successful…
LFF 3.5 SAS/SATA caddy. You need countersunk screws. 2pcs M3x6 or longer countersunk screws to assemle the parts. 4-6pcs 6-32x6 countersunk screws for the 3.5 HDD or 4pcs M3x5 screws for 2.5 HDD. With the 3.5 to 2.5 adapter you can put…
Material: PETG Nozzle: 0.4mm Layer height: 0.2mm Supports: not needed Perimeters: 3 Solid first layers: 4 You need spring contact plates: https://s.click.aliexpress.com/e/_oF6UUyZ This model designed for the wider (16x18.5mm) spring…
You need 4pcs M3x4 or M3x5 countersunk screw to fit the drive in the caddy. Tested servers: FUJITSU Server PRIMERGY RX100 S8p FUJITSU Server PRIMERGY TX120 S3p The v2_rev2 is the best to print. There is no lock mechanism, but it fits…
Nozzle: 0.4mm Layer height: 0.2mm Infill: 100% Perimeters: 3 Supports: no TS0702H 3pin 12V fan controller: https://s.click.aliexpress.com/e/_oo5Pu2F You need 4pcs M3x6mm or M3x8mm countersunk screws to fit the lid/top:…
JEYI Thermal Conductive Silicone Pads: https://s.click.aliexpress.com/e/_omRiFoe Recommended JEYI M.2 2280 SSD Heatsinks: https://s.click.aliexpress.com/e/_oER99GA https://s.click.aliexpress.com/e/_opsow18 There is multiple versions of…
With the v2 version, you can fix the adapter with an M3 screw to the card. But it is not neccessary, the adapter tightly fit to the RAID card. Recommended filament: PETG
Supports: not needed Nozzle: 0.4mm Layer Height: 0.2mm Material: PETG or better heat resistant material (PLA not recommended) You need 4pcs M3x8 counterunk screws to mount the tabs to the adapter. You need 4pcs rubber anti vibration pads…
These are all currently available results.
