Counting matching models…
Kunaï Naruto anime style (full size 320mm) + 3 mm diameter pins (Please note attention that some pins have to be cutted to fit properly) Printed with ABS so this can be glued and smoothed with aceton. Shelf has been added for a good…
Thermistor mount that clip directly on 3030 extrusion frame of your printer/enclosure allowing monitoring of inside temp. Compatible with cylindrical thermistor with diameter of 3 mm Code example for using with Klipper on a BTT Octopus…
Support for LED to be screwed on printer frame 3030 extrusion (length = 47 mm) Should be printed on heat resistant filament like ABS. LED strip with 30° angle and 13mm height LED strip with 20° angle and 10mm height Attached with: 2x…
Here is my design for mounting a carbon square tube and MGN9H rails on RatRig Vcore-3. This also solves some issues while tightening XY joiner plates and pulleys/idlers alignement. Note1: New XY joiners can be used on it’s own with…
Hi, This is a complete X carriage design for Ender3/CR10. It uses a very light and compact twin blower system for part cooling that can be used as a bowden setup or as a direct drive with the new « Sherpa-Mini » by Mellow akka « Libra ».…
Hi, This is a complete X carriage design for Wanhao D12 printer. It uses a very light and compact twin blower system for part cooling that can be used as a bowden setup or as a direct drive with an Orbiter V1.5. Designed for a Dragon…
This is an adaptation of MFBS "Fast-Swap series" to improve weigth while retaining rigidity for MGN9H rails. [20220714] New top mount design featuring integrated slots for endstop. Other compatibilities with original EVA 2.4 remain but…
This is a pass-through support for M10 PTFE coupler. Usefull for guiding filament from spool to your direct drive extruder Fit on 3030 extrusion with 2x M4x12mm cap head screws and t-slot nuts
Simple brackets to hold Vcore3 PSU (Meanwell) on back panel Print Settings Printer: Ratrig V-core 3 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Category: 3D Printer Parts
This is an adaptation of MFBS "Fast-Swap series" to extend compatibility for MGN9H rails and Sherpa-Mini or new Mellow NF Libra. New top mount design featuring slots for integrated endstop. Other compatibilities with original EVA 2.4…
GoPro mounting bracket for 50-60mm rollcage bar Print with 5 perimeters 0.4 width and 75-100% infill
These are all currently available results.
