Counting matching models…
This is my modelling of a standard snap-fit garden hose connector, combined with a 1-inch BSP screw fitting - as often used to connect to garden water pumps. (Note: the hex bolt for tightening was sized to match the outer diameter of the…
A modified clamp for @mobiobi's 'Universal Travel Coffee Gimbal' - it has a little less bend, so it can can clamp smaller bars before the tip of the clamp contacts. Note that this is about as far as you can go (in terms of straightening…
A simple hanger for the squeegee for a shower cubicle - keep it out of the way when you don't need it! Fits nice and tightly on our cubicle, which has 6mm thick glass. Will need to be printed with supports - and some of them are quite…
This is a replacement hanger to attach a Kryptonite bike lock to your bike frame. This is a complete remake, but inspired by an original from Peite, with a few changes: Cleaned up and some fillets added for strength and smoother looks.…
A 2mm spacer for the rear cassette of an SRAM-equipped mountain bike - on my bike, there are five of them between the smaller cogs in the rear cassette. The standard item measures exactly 2mm deep. The 2mm model printed slightly too big…
Allows fitment of Bose headphone ear pads to Sennheiser headphones. (Tested with Sennheider HD206 and Bose QC15 headphones only - YMMV.) I bought some basic Sennheiser headphones (HD206) and found the ear pads thin and uncomfortable. As I…
These are all currently available results.
