Counting matching models…
An alternate roller and axle set for the cereal box filament roller. Tolerance between the axle and the rollers is 0.1mm for a tight press fit (aka a few tap-taps with a mallet). Printed in PETG, 0.2mm layers.
This is a hard shell case for the Planet of the Vapes (POTV) Lobo vaporizer. I wanted something that was a close fit, reasonably airtight to control odors, and had some latitude on the height of the case depending on the glassware in use.…
What is it? An adapter to allow the use of magnetic four-point headgear like from the ResMed F20, F30i, etc. on the Airfit P30i / N30i frame. Why? The back of my head is not well-shaped to retain the normal headgear for the ResMed…
This case is designed for the Elora keyboard kit available from splitkb.com. I wanted the most compact hard case I could come up with since my laptop bag is full enough already. My keyboard is built to be slim, using kailh choc soldered…
Designed for the ResMed ClimateLine hose and the headgear for the N30i / P30i masks. Printed in Polymaker Black ASA, but any filament will work. The top of the headgear hook should print without supports, but you might get a better…
These bases are an alternate I designed to use with ThatRobHuman's great workholding system inspired by Omnifixo. I tried the versions using the countersink magnets, but I didn't feel like the ball or the base was quite secure enough. So,…
This is an insert set designed for my favorite ultra-light Gridfinity bins by ImprovedByDesign over on Thangs, designed to house a Pinecil or TS100 soldering iron, a set of up to 8 additional tips (in either the short or long lengths),…
I printed another hose dryer from Printables a while back, but the creator had designed for a blower motor which was very quiet, but suffered from poor airflow, especially if you used a bit of surgical mask as a pre-filter. This design is…
These are all currently available results.
