Counting matching models…
This is a replacement Lid for the Wii Les Paul Guitar for Guitar Hero. I wanted to route the cable to the outside without damaging the original lid, so I designed my own. Both versions (with and without hole) are available. It prints…
This is ideal to carry your favorite shortcut as a macro key with you and execute it on any computer - with just one click, without any setup! Based on the ingenious Digispark development board for the Attiny85 microcontroller and a…
The Problem The IKEA Vidja lamp is an modern but affordable lamp. Unfortunately it has a crucial design flaw (some might say it is intended): The stability of the whole lamp depends on a little and easy to break plastic clip. The IKEA…
All the available adapters here either had round mounts or were too thick (i.e. a full duplo brick in height), so I quickly made my own with OpenSCAD by using W3asel's very nice Little People mount and a modified version of themelle's…
What is it? This is a headphone holder I made for my old mic stand. It's a simple triangular shape with a hole of 5/8'' (Standard Mic Screw) in the middle, so it is easy to put in a mic stand. It can hold up to 3 headphones with a maximum…
I modified JH3D's wall mount for stacking display boxes to not only look better, but also improve printability. I also converted the mesh into a FreeCAD body. The overall dimensions were preserved. I used 3.5x16mm countersunk screws, but…
These are all currently available results.
