Counting matching models…
I wanted to try my hand at generating an oloid using OpenSCAD that is easy to print. So after generating it, I split it into two parts that can be perfectly aligned for gluing using two pins that are made from small pieces of 1.75mm…
If you don't mind a lightweight oloid (1.3 grams), this is probably the coolest version of my Parametric Oloid that I've discovered yet. It prints in vase mode with a seemingly impossible orientation in just 15 minutes—no glue, supports,…
Herringbone planetary gear fidget on a comfort fit ring you can spin! Random seam position is required for it to be able to spin. See Required Print Settings below. A very quick print that uses ~ 2.6 grams of filament. Ring sizes are…
Bring back that 1980's nostalgia with 3D printed spoke beads! Pedal slow for awesome sounds. Designed for 2.0 mm spokes. Recommended Print Settings I would start with the Normal Tightness (1.7 tightness factor) files. Count the number of…
I recently read about a kirigami-inspired soft robotic gripper developed at North Carolina State University, and I wanted to create an FDM 3D-printable version to play with. The full article about how it works was published in Nature:…
Do not enable supports , and you must print the inner ore first , because you will need to flip it upside down and drop it inside the outer shell during a print pause. It acts as a support for the entire top of the block, and will…
For many years I had been trying to find large retro-style hair bobbles, but nothing matched what I was looking for. So I designed one myself around scünci brand “no damage” hair elastics (part numbers 17278 or 17829) and made it…
When I retrieved my XBox 360 Wired Controller from my box of electronics to use it for some retro PC gaming, the proprietary round to USB adapter was gone and the controller was useless to me until I was able to find it again. Once I…
A tiny (smaller than a “D” battery) multi-stage planetary gearbox powers the Tiny Toroidal Twist Fan , which definitely punches above its weight! A flywheel keeps the fan spinning between twists for a continuous breeze. Includes both a…
If you break the rear wing spoiler on your Rustler 2WD, you can't just purchase a replacement for the rear wing spoiler, it only comes with an entire body. I printed mine with 0.2mm layer height in PETG using the defaults. It prints flat,…
This model is for single extruder printers. If you have ever done a filament change at a certain layer, you can handle this! There are a total of two color changes (three if you count the superfluous one in the very beginning). When it…
The tolerances are tight, and it might require some muscle to force the speaker-end of the cord through, but it doesn't even wiggle in the outlet. Print using build plate only supports with the side facing the outlet on the print bed.
These seem to fall off while bashing, so I measured one that I haven't lost yet, so I can keep my cars running. I printed 4 instances at once using PETG, 0.2mm layer height, in the default orientation with 99 perimeters, using…
I'm a pretty big fan of Smosh , and their drunken live event last night was so awesome that I wanted to see if I could 3D print its logo with Sloshy the Red Solo Cup on it. This is designed for single extruder printers using M600 as the…
One of the plastic pieces on my wife's favorite easel (Winsor & Newton 7006210 Bristol Aluminum Sketching Easel) broke, so I measured it, coded up a replacement, and printed it. It uses a cam-lock to tighten against the aluminum…
These are all currently available results.
