Counting matching models…
I bought for my kid the “Smoby - Black+Decker - Etabli Bricolo Center” which uses 20 of the "92 Accessoires" as mandatory use for mounting it. I took it as a challenge to recreate the screws & nuts so that my son could use the ones meant…
Here is my first attempt at correcting misalignment of the PVC blades of my blinds. I needed to keep them aligned in order to not grind the mounting screws of my newly installed Avosdim solar conversion kit . TL;DR it did not do the job,…
I had this project cooking for several months now, mainly because I had to take a break and actually play the game but today I decide it's time to showcase the end result of my 3D-printed Hackclaw figurine based on the original model. The…
EDIT 30th Aug 2026: Added TRUNK and CRASHBLOCK for testing on the Ender 3 v3 KE. Replace the Trunk from the SE set with the provided one in case your hotend is higher than the SE. Attach the crash-block on the top of the CR-touch as such:…
I needed a new spot for my portafilter and filters so that I would not loose them in the kitchen mess. Also a place and position where they would dry. Normally I used the top of the coffee machine but then I needed to place a laptop on…
Having enough cleaning all the grid holes of your Bosch Grinder? I was too, then decided to make this little cleaner device that will clear all the holes at once! It's also a torture test for your printer. I printed it with all the pins…
After buying the “Smoby - Black+Decker - Etabli Bricolo Center” and re-purposing the mounting screws & bolts, my son was lacking extra storage for them, until I tried to re-create it in FreeCAD. This is one of my first 3d designs so it's…
My most successful/useful yet very specific print so far. My wife always had trouble keeping her shampoo bottle upside down to get the last of it, and annoyed to knee down to fetch it from the floor. So I designed her this bottle-holder…
Tubes: 10mm & 28mm Drain: 77x40mm Included FreeCAD project, if yours is slightly different.
I had a very common problem yet a very specific need. I converted my manual rolling shutters into electric ones using Avosdim solar conversion kit , but my installation was too tight and the rolling shutter blades would misalign…
I wanted to train myself using the Zigbee protocol on a simple project such as this one. This uses the supermini ESP32-C6 and an AHT10 sensor. The code to run it is mostly from the example library from Arduino-Zigbee, tuned to fit my…
Always Z-ready crash-block for the filament cutter. The print head only has to swing on the side when it needs to. Keeps the print-area original size by retracting the arm when not in use. List of Materials: 1x ES3004 servo OR MG90S…
These are all currently available results.
