12 models
Simple housing with sliding lid with a secure “click” closure. Many thanks to TuTu for the fantastic template! Hint: Switch off via the meshtastic app, switch on by pressing the reset button. This saves an additional switch. Battery: I…
Simple housing with sliding lid with a secure “click” closure. Many thanks to TuTu for the fantastic template! Switch and charger board from amazon - see photo… The tabs for the screws must be removed from the switch. Simply bend them…
A component that can be placed between the two circuit boards to secure the antenna connector. I've had the connector come loose before - but with this antenna clamp, the connector is now secure and can no longer come loose accidentally.…
This is a remake from "NodeBrix Modular Case System" from "Open Source Country". Thanks for the great work!!! I only remaked the frame for the RAK19007 for n-type antenna and the front (and back) cover. Printed with PLA on Anycubic i3…
(Deutscher Text weiter unten) Hi! This is a housing for an ESP 8266 Lolin V3 with a 1.8 inch TFT display. No screws are needed. The ESP is first placed on the bracket and fitted into the housing. Then the display mount goes on top. The…
This 3mm wider case is a remix from the genious original “RAK Meshtastic Starter Kit - No Additional Hardware Case” from pdxlocs. I also used two other remixes here for the frame and the front and back cover. The frame can hold the GPS…
(english text below) Moin! In meinem Dacia Dokker verabschiedet sich ab und an mal die Kofferraumabdeckung - und saust mit lautem Getöse in den Kofferraum. Da ich dabei jedesmal zusammenzucke habe ich nun diese Teile entworfen, die der…
Do you need to estimate story points for your agile project? Here is the solution - the fibonacci story points cube! Take the dice and roll the story points... ;-) It has been found that printing without support gives the cleanest result.…
I like my otterbox commuter - but it's very thick and won't fit in most phone stands. So I decided to make another one to support devices up to 14mm thick. Print Settings Printer Brand: Anycubic Printer: All-metal Mega **Rafts:** No…
This is another WLED project featuring a 16x16 LED matrix and an ESP32. All parts are printed in white PLA and designed so that they simply snap together—no screws are needed. The extra hole in the base is for an optional microphone,…
Because the diffusers I found on thingiverse do not fit well on my nitecore tup (they go too hard to slide on the lamp) - I made a new one. It fits on my lamp and leaves the display free. No support and opening upwards - in my case in…
To get the antenna 4m higher you can clip this adapter to your leifheit mop and attach your meshcore / meshtastic device. See enclosure for RAK or Xiao in my other models.
These are all currently available results.
