Counting matching models…
I recently purchased an airsoft replica of a 3.8 Vorsk Hi-capa and I obviously wanted to display it. Found the stand made by @CedricD, but it isn't intended for the Hi-capa platform. So I decided to remix his design. I also took the…
Needed a small encoder knob to fit the Pikatea R26. I didn't have set screws to use the original knob from Pikatea, so I made this one to fit snugly around the shaft of the encoder. Made to fit rotary encoders with a flat side on the…
Introduction : This is a replica of the “tactical M-lok / Keymod pocket panel” by WADSN to hold a momentary switch on a handguard. You will find two versions, one with the same length and hole placement than the original (in black in the…
Introduction : This is a knob for the selector switch of the CZ Scorpion Evo 3 by ASG. I made it to replace one of the sides of the selector (in my case the right side) to prevent the end of the knob to pinch my finger while using my…
These are all currently available results.
