Counting matching models…
A mount for the Raspberry Pi HQ Camera to sit inside the top of the frame looking down at the build plate. When combined with the 6mm wide angle lens, provides clear shots of the whole bed during a print. Bill of Materials 3 Printed Parts…
A Filament Sensor Cover for the Prusa i3 mk3 Bondtech extruder upgrade, with space for a threaded brass insert to be pressed in to allow for the attachment of a Bowden tube. This allows for its use in the original prusa enclosure. The…
This is a mount for a Molex Mini-Fit 8 pin connector. It fits into the space that the power quick disconnect would normally go. This provides enough pins to connect up the earth wire needed for the Mk4.
The STC-1000 is a temperature controller that can be used to run a heater to maintain a constant temperature in your enclosure. This case houses the STC-1000 in the corner where the small thermometer normally resides. It provides two…
Don't download this - download the original at https://www.printables.com/model/502515-bear-upgrade-for-prusa-i3-mk4-mk35-mk39/comments This is here for communicating with the original creator about tweaks to his design.
A little compact bit driver with a nice shape, and space to store 4 little bits.
This is a bracket to mount a Raspberry Pi inside a SmartiPi case on top of the Original Prusa Enclosure. It includes a hole that lines up with the hole in the top of the enclosure through which you can guide wires. You do however need to…
What is this? It's a calibration cube. It can be used to make sure that your printer is making things the absolute correct size for those times when you absolutely need precission. Why should I use this one? There's a “traditional” xyz…
End Caps for 4040 and 4080 aluminium Extrusion. Bosch Rexroth profile.
These are all currently available results.
