Counting matching models…
UPDATED: New Reset Button, New Front Cover ; moved the antenna to be on the same side as the port cover and environment sensor to sit flat. New folder has best orientation, tree auto supports for front cover , now has room for a…
This is an enclosure for the Arducam 1080p Day/Night USB camera . I needed to make a baby monitor for someone and had a raspi zero 2 and arducam to get started . Here’s an enclosure that uses (4) 16mm M2 screws and heat inserts. My board…
Bird house node with 1.5" diameter entrance hole, vented body and floor plate, vented roof with drain and grate to ensure it does not hold water while keeping electronics off the bottom of the roof. The body is approximately 150mm x 150mm…
Shout out to Slabua , building his Heltec v3 case introduced me into LoRa , got me curious about CAD and thus helped lead me to this creation; thanks for sharing your build ! This folding case fits the Heltec ESP32 V3 LoRa board intended…
This model is my first CAD design and first upload. The goal of this build was to design a replacement cover for a speaker cover that broke using the part design workbench and linear array tool in freeCAD, export the STL and upload to the…
The need came to replace the stock drain tubes for a 1986 Jaguar X series and with some adjustments to the print settings, was able to design and print these parts successfully with materials exceeding the 125C OEM standard for…
Gutter Bracket for Outdoor Lighting; fits most standard outdoor lighting fixtures with optional 2.5" riser. Lights can fasten directly to the mount or to the riser that is then attached to the mount. The gutter mount has a built in spacer…
Smaller dome mount for outdoor lighting fixtures with diameter of 22.5mm . Print using ASA. Mount is approximately 2.5" in overall diameter. No supports if printed with threaded end facing build plate. 4 wall loops suggested, 0.18 layer…
This adapter is compatible with most 22.5 mm out door lighting fixtures and accessories. Printed in ASA with supports. if you would like to leave a tip thank you Ltc M9w6KnukrPLUT9EZ5YaWtoJe54ZeywG27B Btc…
”The Pod” Here is an enclosure for the E213 LoRa device by Vision Master . Install the buttons then connect the Lora antenna, then slide the 213 board into the enclosure, slide the gps in using the two small rails positioned anove the…
printed using 0.4mm nozzle on creality k1 max, 270C nozzle temp, bed temp 90-100C , 1 wall loop, 100%infill using ASA filament 2mm and 3mm thicknesses
Completely redesigned the gutter mount in FreeCad, the main dimensions are roughly the same as far as width and length. I used 22.5mm thread with pitch=2 . This fits most standard low-voltage lighting fixtures. Works great in gutters as…
These are all currently available results.
