P
Printablesfluffyeggs
AD5M LED Light Bar 6x3 Magnets
Print at .2mm layer height. The holes are sized .1mm over so that the magnets are a snug press fit.
- Downloads
- 175
- Likes
- 21
- Rating
- 5
All models
Counting matching models…
P
Printablesfluffyeggs
AD5M LED Light Bar Diffuser Panel
Replaces the LED strip clasp pieces with a full cover diffuser. I left a large gap under the end support so there is space for wiring. The supports are spaced 50mm apart to line up with the solder pads on 5050 300led strips. Print with a…
- Downloads
- 66
- Likes
- 20
- Rating
- 0
P
Printablesfluffyeggs
RV baggage door latch spacer
This is a spacer that goes between the skins of a RV baggage door. It allows the latch cylinder to be tightened down securely. Without this the stryofoam core just crushes and the latch is never tight. The gap should point down so any…
- Downloads
- 18
- Likes
- 5
- Rating
- 5
P
Printablesfluffyeggs
E3D Hemera Eddy Coil Mount
This mount puts an BTT Eddy Coil inline with the nozzle on a E3D Hemera extruder. There is 4mm of vertical adjustability. The bottom of the travel should but the probe at the same height as the nozzle. There is also a little bit of side…
- Downloads
- 13
- Likes
- 3
- Rating
- 0
P
Printablesfluffyeggs
Paper tray stacking clips
These clips allow dollar store Jot brand paper trays to be securely stacked into a mailbox system. There is a dovetail joint at both ends to allow for expansion. I modeled a small bit of tolerance into the dovetails so no adjustment…
- Downloads
- 6
- Likes
- 2
- Rating
- 0
P
Printablesfluffyeggs
Reduplicator z axis top bracket for front mount
I added 2.5mm more clearance on the gusset section of this part. The screws that are used to fix the x-axis rods in place where just barely rubbing on this bracket. Now I can use the full z height without any rubbing or binding. This will…
- Downloads
- 6
- Likes
- 2
- Rating
- 0
These are all currently available results.