Counting matching models…
A modified version of the Radial Lizard, made to be less likely to catch on clothing. The mesh is a bit scuffed, but it prints fine. All credits go to the original author (Jimothy Perkins, according to ctrlpew.com). Links to the original:…
Super low-profile latch, intended for boxes with >= 3u bottoms. Print it with a brim. No supports needed. The mesh is a bit scuffed, but it prints fine.
Remix Description All credits go to the original author, license is the same. This remix is more durable and easier to print. I cut off the sharp corners in the finger slots since attempting to print super sharp features result in fragile…
I wanted to retain the style of the original, but make it safer and shaped more like a laptop brick so it doesn't take up so much space. It uses the original computer-side cable, but a different AC plug as I wanted to connect ground.…
Features: Should fit most common hot glue gun variants, big and small. Modeled after a small variant, however the trigger well of V2 has been improved to accommodate larger sizes. If you have the ability to cut out a small piece of sheet…
V4 (Experimental) Now Available Finalized version of V3, with a few clean-ups. Added tab slots for compatibility with certain fan mods. I will print this one out and confirm its proper, then this is likely going to be the final version.…
Important Notice A new version with various improvements is in the works. Should address various minor flaws with the current model that I've been running so far. Z-Axis Blocks Custom Z-axis blocks, supports oldham couplings on the bottom…
Mecha-styled adapter for the SV06 PLUS to attach a 40mm fan, i.e a quiet Noctua. Important Note: I would honestly advise against printing this, you're unlikely to get enough cooling from a 40mm fan. I ended up switching to this 5015 model…
Is the adhesive on your rubber feet failing? Do you want more space under the printer (maybe to put a tray to catch filament poops)? Re-uses the original rubber pieces, but grips the sides of them so they don't fall off Moves the feet to…
I advise printing in a non-porous material or treating the surface of it. I didn't do any of that though, I just used regular PLA lol. It is intentionally slightly undersized, as the bent wires of Krokfjorden will vary somewhat from unit…
Modified to remove the bottom corner edge to provide more clearance.
Lets you mount an IKEA Lönsås 210x300mm mirror to the back of the printer, to easily inspect prints for issues. The mirror can be angled, the arms should clear the bed heater cable, and the arms are attached by sliding brackets for easy…
Reverse-engineered dimensions based off of official STL of the terminal block, with a lot of trial and error to get it to fit securely.
A jig with a variety of holes and slots for the different lighter mods I do. Unlikely to be of much use to other people, but I'm uploading it anyway so I won't lose the files - and in the unlikely event someone may find it useful. Takes…
Allows you to fit 10U of 10" gear horizontally (rotated 90°), in 6U of a 19" rack. Context At the time of writing, only two prior implementations of this exist online - one cut from sheet metal (great choice, but expensive), and one 3D…
Fits a keyboard switch into a keystone slot. Note: Orient the switch in the correct direction or it will not fit. Latches one of the switch tabs onto the adapter, and the other tab onto the keystone panel itself - the panel must be…
The lower washer mount is press-fit into the stock motor mount. The mounts have some clearance for the motor shaft; the bearing and upper washer are allowed to shift around by about 1mm. This is intentional, we do not want to grip things…
These are all currently available results.
